How people actually become ill
Legionnaires’ disease is a pneumonia caused by inhaling Legionella bacteria in water droplets small enough to reach the deep lung — typically between one and five micrometres. This is why the risk is associated with anything that makes an aerosol: showers, taps with aerators, spa baths, humidifiers, cooling towers, evaporative condensers and pressure washers fed from a stored water supply. Drinking contaminated water is not considered a significant route of infection, and the disease does not spread from person to person.
Most healthy people who are exposed do not become ill. The risk rises with age, smoking, heavy alcohol use, diabetes, chronic lung or kidney disease, and any condition or treatment that suppresses the immune system. That means the population in a care home, hospital or supported-living scheme is exactly the population a water system needs to be controlled for.
What Legionella needs to multiply
The bacteria multiply in water between roughly 20°C and 45°C, with the fastest growth around 37°C — human body temperature. Above 60°C they are rapidly killed; below 20°C they are largely dormant but survive.
Warmth alone is not enough. Legionella survives and grows inside other organisms in the water, particularly amoebae and biofilms, which protect it from chlorine and make routine disinfection less reliable than many people assume. Sediment, rust, scale and dead ends in pipework all provide the nutrients and shelter that turn a storage tank or an unused outlet into a breeding ground.
Where it hides in a typical building
In domestic water systems the usual suspects are predictable: cold water storage tanks (especially uninsulated or poorly sealed ones, where stored water warms up), calorifiers and hot water cylinders where stratification creates a warm zone, long runs of pipework to rarely used outlets, dead legs left behind after refurbishment, shower heads that are never flushed, and TMVs with blocked strainers.
- Cold water storage tanks above 20°C, or with sediment on the base and a poorly fitting lid
- Calorifiers where the base never reaches 60°C
- Little-used outlets, outside taps and dead legs
- Showers and spray taps in rooms that are rarely occupied
- Cooling towers, evaporative condensers and spa or whirlpool systems
Why monitoring alone is not proof
Temperature checks and visual inspections tell you whether a system is likely to be under control. They do not tell you whether Legionella is present. A tank can look clean and hold water at the right temperature while biofilm on the outlet pipework continues to release bacteria.
Routine sampling is the check that can contradict your assumptions — and it is the evidence an insurer, a local authority or an HSE inspector will ask to see alongside your risk assessment and records. Sampling is not a substitute for controlling the system; it is the verification that the controls you have are actually doing the job.
What good practice looks like
A risk assessment that is specific to the building, a written scheme of control that sets out what is done and how often, competent people carrying it out, recorded results, and a clear action plan for when something goes wrong. Sampling frequency and sample points should come from the risk assessment, not from a generic template.
If you have never had a Legionella risk assessment, or it predates a significant change to the building or its use, that is the place to start. Everything else follows from it.
This article is general guidance, not a site-specific risk assessment. Control measures for your building should follow your written scheme of control and the Approved Code of Practice L8 with HSG274.